
Austin Commercial Heat Pump Rebates
Header image: illustration of the type of work described, not a photo of a CG Service Pros project.
Yes, heat pumps qualify. Austin Energy's commercial rebates cover a broad range of DX heat pump systems: split systems, package units, ductless mini-splits, VRF, packaged terminal heat pumps and single vertical units, plus some water-source and ground-source heat pumps. Every application needs the equipment's AHRI rating, and the application has to be in before installation. CG pulls the AHRI data and files the application before any equipment goes in.
The rebate itself depends on the system type, its size in tons and its efficiency rating. This post covers which heat pump categories Austin Energy lists, what AHRI data the application needs, and the rules that most often decide whether a heat pump project qualifies. If you already have a unit in mind, request a site walk and we will check it against the list.
Which heat pump systems are on Austin Energy's list
Austin Energy's Commercial HVAC page names the systems most common in small and midsize buildings: package units, split systems, ductless mini-splits, variable refrigerant flow (VRF), packaged terminal units and window units. The HVAC Incentive Summary breaks heat pumps out by type and size.
| Heat pump type | Sizes on the summary | Rating that sets the tier |
|---|---|---|
| Split system or package unit | Under 5.42 tons | SEER / SEER2 |
| Split system or package unit | 5.42 to under 20 tons | EER |
| Split system or package unit | 20 to under 63.3 tons | EER |
| Split system or package unit | 63.3 tons and larger | No heat pump incentive listed |
| Packaged terminal heat pump (PTHP) | From 0.1 tons up, in size bands | EER |
| Single vertical heat pump | All sizes on the summary | EER |
| Water-cooled heat pump (water loop or ground water, water-to-air or water-to-water) | Only units smaller than 11.25 tons | EER |
Ductless mini-splits and VRF are named on the HVAC page as eligible DX systems. CG confirms which incentive category your specific system falls under before we price it. Chillers have their own separate rebate.
The summary we checked is dated September 11, 2024. Austin Energy says offerings and rebate levels can change without notice, so CG checks the current version before your proposal is written.
Why the efficiency rating sets the rebate
Austin Energy calculates commercial HVAC rebates with a simple formula: number of units, times tons per unit, times the incentive per ton for that efficiency tier. Higher efficiency moves the unit into a higher tier.
Two details matter for heat pumps:
- The tiers are set by cooling ratings, SEER2 for smaller units and EER for larger ones, even though the equipment also heats. Austin Energy pays for reducing summer peak demand, so cooling efficiency is what moves the number.
- The lowest tier may pay nothing. On the current summary, small split and package heat pumps at the bottom efficiency tier have no incentive listed. A unit that only meets code may earn no rebate at all.
Austin Energy also requires rebated equipment to beat the efficiency requirements in the City of Austin Energy Code. When we put options in front of you, we compare the AHRI ratings first. A cheaper unit one tier lower can end up costing more once the rebate is counted.
What AHRI data the application needs
The application must include the manufacturer's rating based on AHRI (Air Conditioning, Heating and Refrigeration Institute) standards. In practice, CG gathers this before the purchase order:
- The AHRI certificate for the exact equipment. For split heat pumps, the rating belongs to the matched outdoor and indoor combination, so the certificate has to list both model numbers you plan to install.
- Manufacturer spec sheets and AHRI cut sheets for the equipment being installed.
- Rated capacity and efficiency: tons, plus SEER2 or EER depending on size.
- For water-source, ground-source, geothermal and water-loop heat pumps, a rating at 86°F entering water, which Austin Energy requires for those systems.
Austin Energy accepts spec sheets, AHRI documents and the quote by email after the online application is submitted. Even so, the file is not complete until they arrive, so we send them with the application. Incomplete applications go on hold and may be cancelled after 90 days.
Other rules that decide whether a heat pump qualifies
Our pre-approval checklist covers the full list. The rules that come up most on heat pump jobs:
- Apply before installation. Retrofit and replacement rebates are not paid retroactively. New construction must apply before the certificate of occupancy.
- The equipment must run weekdays from 3 to 6 p.m., June through September. Schools and houses of worship are exempt.
- Electricity must be the primary or secondary fuel. Heat pumps meet this by design, which helps when replacing gas-heat rooftop units.
- Backup or redundant systems are not eligible. A standby heat pump that only runs when the main unit fails will not qualify.
- New, energized equipment with at least a one-year warranty, installed in a permanent building.
- Prior rebates count. If the same equipment got an Austin Energy rebate within the past 10 years, the new rebate is calculated on incremental savings.
- ECAD applies to buildings over 10,000 square feet, unless exempt or outside city limits.
Why look at heat pumps in winter
Heating season is when weak equipment shows itself. A heat pump that struggles on a cold morning, or electric heat strips that run all day, usually show up first as tenant complaints and high winter bills.
Winter is also a practical time to plan a replacement. Austin Energy may schedule a pre-installation site visit to verify the existing equipment, so the old unit has to still be in place. Scoping now, letting CG file the application, and installing in spring gets new equipment running before the June to September operating window starts.
If a unit fails outright, call us before it is replaced. Austin Energy evaluates emergency replacements case by case, and CG raises the request with the program before the old unit comes out.
From the field: "When a building moves from electric strip heat or gas heat to a heat pump, set up the backup heat and thermostat lockouts carefully. If the strips kick on every time the thermostat moves, the tenant pays for it and blames the new system."
CG's field team
Matching the system to the building
A few common Austin situations and the heat pump categories that fit them:
- Small office or retail building with rooftop package units. Package heat pumps are a direct swap for many gas-heat rooftop units, subject to curb, electrical and duct conditions.
- Hotels, senior living common areas and mixed-use buildings with through-wall units. Packaged terminal heat pumps replace PTACs in the same wall sleeves when sizes match.
- Offices with many zones or limited duct space. VRF and ductless systems are often the better fit. Our post on VRF vs rooftop units for Austin office buildings compares the two.
- Buildings already on a water loop. Water-source heat pumps under 11.25 tons are listed, with the 86°F rating requirement.
Each of these still has to pass the same application rules. The system type only decides which table the rebate comes from, and CG sorts that out during scoping.
Who gets paid
By default, the rebate goes to the customer on the Austin Energy electric account. A participating contractor can receive it if it is a registered City of Austin vendor, is registered in Austin Energy's rebate processing system, and has a letter signed by the account holder authorizing the payment.
CG Service Pros collects the rebate directly from Austin Energy at the end of the project. Our proposal lists the full project price, the estimated rebate and the balance the property pays.
A few caps apply to every commercial project. Standard rebates cannot exceed 50% of total job cost. Locally owned small businesses, small nonprofits and houses of worship that qualify for the 30% bonus can reach up to 80% of job cost. The maximum combined rebate is $300,000 per site per fiscal year, which runs October through September. Funding is first come, first served.
Frequently Asked Questions
Do heat pumps qualify for Austin Energy commercial rebates?
Yes. Austin Energy's commercial rebates cover DX heat pumps including split systems, package units, ductless mini-splits, VRF, packaged terminal heat pumps and single vertical units, plus some water-source and ground-source heat pumps.
What AHRI data does Austin Energy require?
The application must include the manufacturer's AHRI-based rating. Include the AHRI certificate for the exact matched system, spec sheets and AHRI cut sheets. Water-source, ground-source, geothermal and water-loop heat pumps must be rated at 86°F.
Do VRF and mini-split systems qualify?
Both are named on Austin Energy's Commercial HVAC page as eligible DX systems. CG confirms which incentive category applies to your equipment before we price it.
Are large heat pumps eligible?
The current incentive summary lists split and package heat pumps up to 63.3 tons. It shows no heat pump incentive at 63.3 tons and larger, and water-cooled heat pumps are listed only below 11.25 tons.
Can I get a rebate after an emergency replacement?
Rebates are not paid retroactively. Austin Energy evaluates emergency replacements of failed equipment case by case, so call us before the unit is replaced and we will raise it with the program.
Who receives the rebate?
The account holder by default. A registered contractor can receive it with the account holder's signed authorization. CG Service Pros collects the rebate directly from Austin Energy at the end of the project.
Next step
CG Service Pros was named Austin Energy's 2024 Contractor of the Year and has handled rebate projects for more than five years. If a heat pump replacement is on your list for spring, request a site walk or call us at (512) 843-7444. We review the existing equipment, write the scope, file the pre-approval application, install the new system and collect the rebate directly from Austin Energy. Have the equipment list, nameplate photos and your Austin Energy account number handy. You can also read more about our Austin commercial rebate work.
Sources
Program details checked November 9, 2026: