
Air Sealing vs Attic Insulation in Austin
Header image: illustration of the type of work described, not a photo of a CG Service Pros project.
Attic insulation is an established Austin Energy multifamily rebate, paid per square foot based on how much R-value the project adds over rental units. Air sealing is newer. Austin Energy's 2026 multifamily handbook adds an air infiltration and weatherization measure for door seals, door sweeps, weatherstripping and caulking. The public rebate summary does not list it yet, so CG confirms whether it applies to your property during the site walk, before it goes into a scope.
There is also some overlap. A properly done insulation job already includes sealing at the attic hatch and around certain fixtures. Here is how the two measures compare, which one should go first, and how we document each one so the rebate gets paid. If you would rather have us look at your attics now, request a site walk.
The short comparison
| Attic insulation | Air sealing (air infiltration and weatherization) | |
|---|---|---|
| What it does | Slows heat moving through the attic floor into or out of units | Cuts outside air leaking into units through gaps |
| Where the work happens | The attic, above rental units | Unit doors, plus gaps around vents, plumbing and exhaust penetrations |
| On the public rebate summary? | Yes (Multifamily Rebate Program Summary, April 2024) | No. It appears as a new measure in the 2026 handbook |
| How the rebate is figured | Dollars per square foot, rising with the R-value added | Not on the public summary yet; CG confirms current terms during scoping. The handbook describes documentation by door gap size and feet of weatherstripping |
| Property limits | Attic over mechanically cooled rental space, sound roof, no rodents | Properties with electric or heat pump systems only, with visible gaps present |
| How it is checked | Depth markers, before photos, insulation certificate, inspections | Air leakage testing to BPI standards (or visual review where testing is unsafe), gap records, photos |
Program details change. Treat this table as a starting point. CG confirms current requirements for your property during the site walk, before anything is budgeted.
What the attic insulation rebate covers
The measure pays for insulation installed between the roof and a mechanically cooled space, in rental units only. The amount is calculated per square foot and depends on the difference between the existing insulation level and the final level. The per-square-foot amounts are set by Austin Energy and change, so we do not list them here. Your CG proposal shows the estimated rebate for your attics.
The 2026 handbook adds a few property conditions worth checking early:
- The existing average insulation has to be below a set level. An attic that is already well insulated will not qualify.
- The roof has to be free of damage, and the attic has to be free of rodents.
- Spray foam does not qualify for the rebate, though it can be used to fill minor gaps.
As with every Austin Energy multifamily measure, the work needs written approval before it starts. CG handles that paperwork before anyone goes into the attic. Our post on Austin Energy attic insulation rebates for apartments walks through the approval steps in order.
What air sealing covers at Austin Energy
The 2026 handbook describes air infiltration and weatherization as work that reduces the rate of outside air leaking into units. In practice that means door seals, door sweeps, weatherstripping, and caulk at gaps where outdoor air gets into conditioned space.
The eligibility rules are specific:
- Only properties with electric or heat pump systems qualify. A gas-heated building should not count on this measure.
- Gaps have to be visible around vents, plumbing penetrations or exhaust vents.
- Doors must lead from conditioned space to the outside, or to an unconditioned space such as a garage. Utility and mechanical closet doors never count.
- Doors with screen or storm doors are not eligible.
- Gaps of at least 1/8 inch are required, and roughly 70% of the qualifying doors need visible gaps.
So, is air sealing rebated on its own? On paper, the handbook treats it as its own measure. The public rebate summary does not list it or a rate for it yet. CG confirms whether the measure is active for your property before it goes into your scope.
Sealing that already comes with insulation
Even without a separate air sealing line, the handbook's insulation spec requires several sealing steps. Crews weatherstrip the attic hatch perimeter. They seal the boxes built around recessed lights that are not rated for insulation contact, using high-temperature caulk. Open wall cavities get covered with fire-rated material, and dams go up around flues and hatches. Those are some of the biggest attic leaks in older apartment buildings, and they get closed as part of the insulation job.
Which comes first
Work from the attic down, and fix what insulation would bury before it gets buried.
- Ducts. The handbook calls a sealed, leak-free duct system "often a prerequisite for additional measures such as attic insulation." If ducts in the attic are disconnected, crushed or leaking, address them first.
- Attic prep and attic-floor sealing. Hatch weatherstripping, recessed light boxes, open cavities, junction box covers, and baffles at soffit vents.
- Insulation. Blown to the approved depth, with markers in place.
- Door and unit weatherization. This happens at unit doors, not in the attic, so it can run on its own schedule.
Why this order matters: once 10 or 12 inches of insulation is down, gaps and duct problems underneath it are hard to find and expensive to reach.
From the field: "Walk the attic before anyone prices insulation. Disconnected ducts, open chases over mechanical closets and bare junction boxes all need attention first. Blowing insulation over a problem only hides it until the next inspection."
CG's field team
How each one is verified
The two measures leave different paper trails. CG handles both, so the property does not have to track them.
Attic insulation. The handbook calls for depth markers about every 300 square feet, stapled to the framing and visible from the hatch. Crews photograph existing conditions with the markers in place before any insulation is blown. An insulation certificate at the attic lists the insulation type, depth, install date, contractor and fire rating. Austin Energy then inspects the work.
Air sealing. Air leakage is assessed through testing that follows Building Performance Institute (BPI) standards. Where testing is not possible or not safe, for example where asbestos may be present, a visual assessment may be accepted. Our crew records the gap size for each qualifying door, totals the feet of weatherstripping installed, and photographs a sample of door gaps with a tape measure showing the gap.
We hand the property the door-by-door list at the end. It helps on future turns.
Why winter works for both
Attic work is safer and faster when the attic is not baking, which is why fall and winter suit insulation projects in Central Texas. Drafts are also easiest to find when residents are calling about them. One practical note: the handbook says door seals and sweeps go on clean, dry surfaces above 20°F, so a hard freeze can pause door work for a day or two.
Who gets paid
By default, Austin Energy pays the rebate to the account holder. A contractor can receive it instead if it is a registered City of Austin vendor, is registered in Austin Energy's rebate processing system, and has a letter signed by the account holder authorizing the payment.
CG Service Pros collects the rebate directly from Austin Energy at the end of the project. The property signs the authorization letter at the start. Our proposal shows the total project cost, the estimated rebate and the balance the property pays on separate lines, so the net cost is clear before anyone signs.
A short checklist before you ask for a scope
- Heating type in each building: electric, heat pump or gas. This decides whether air sealing is even possible.
- Which attics sit over rental units, and which sit over common areas.
- Photos from a few attic hatches showing current insulation depth.
- A rough count of exterior unit doors, and which ones have storm or screen doors.
- Any Austin Energy rebates the property received in the last 10 years for the same work.
- Known duct problems or comfort complaints by building.
Frequently Asked Questions
Does Austin Energy give a rebate for air sealing in apartments?
Austin Energy's 2026 multifamily handbook includes an air infiltration and weatherization measure covering door seals, sweeps, weatherstripping and caulking. It is not listed on the public rebate summary yet, so CG confirms whether it applies to your property during the site walk.
Does an attic insulation project include any air sealing?
Yes. Austin Energy's insulation spec requires weatherstripping the attic hatch, sealing boxes around recessed lights that are not rated for insulation contact, and covering open wall cavities before insulation goes in.
Should air sealing or insulation come first?
Ducts and attic-floor sealing come first, then insulation. Door weatherization happens at the units, so it can be scheduled separately.
How does Austin Energy verify attic insulation?
Through depth markers, before photos taken with the markers in place, an insulation certificate at the attic, and inspections after the work.
Can a gas-heated property get the air sealing rebate?
The 2026 handbook limits the air infiltration measure to properties with electric or heat pump systems. Gas-heated buildings can still look at attic insulation and other measures.
Can the contractor receive the rebate?
Yes, if the contractor is a City of Austin vendor, is registered in Austin Energy's rebate system, and has a signed authorization letter from the account holder. CG Service Pros collects the rebate directly from Austin Energy at the end of the project.
Next step
CG Service Pros was named Austin Energy's 2024 Contractor of the Year, has handled rebate projects for more than five years, and counts the Housing Authority of the City of Austin (HACA) among its clients. In a single year, our team completed more than 4,500 multifamily units. If you are weighing insulation, air sealing or both, request a site walk or call us at (512) 843-7444. We assess the attics and doors, write the scope, do the work, file the Austin Energy paperwork and collect the rebate directly, so your proposal shows the net cost up front. You can also read more about our Austin multifamily rebate work.
Sources
Program details checked November 9, 2026:
- Austin Energy, Standard Rebates for Multifamily Properties
- Austin Energy, Multifamily Rebate Program Summary (updated 4/10/2024)
- Austin Energy 2026 Multifamily Rebate Program Handbook (revised August 20, 2026): Technical Specifications for Attic Insulation, Air Infiltration/Weatherization, and Duct Replacement